Skip to content

?

단축키

Prev이전 문서

Next다음 문서

크게 작게 위로 아래로 댓글로 가기 인쇄 첨부
?

단축키

Prev이전 문서

Next다음 문서

크게 작게 위로 아래로 댓글로 가기 인쇄 첨부




[Picture1]

Spectral Sensitivity Characteristics of ICX098 CCD chip used in the Philips ToUcam.

As can be seen the spectral response of this CCD when used for producing RGB images from splitting from the master colour image will not produce data of the same quality as of the images had been obtained through the proper filters.

The problem lies in that, the response of the chip in Blue and green overlap a great deal at ~475nm. Also, a R leak occurs going far back into the 450nm range. Note that simply using an IR block filter will only help a little to cut the R end of the response down, but the problem still lies in G-B overlap, and the red leak.

This in summary means that the Blue image data is “polluted” with G and R (which is why the surface features remain visible, even when an IR block filter is used.) Also, the G image data is slightly polluted by the Red leak.

In further reviewing the documentation, the way in which the CCD reads the data out also causes problems, as 2 x as much G signal is generated than R or B.

We present one possible solution to this problem below.

[Picture2]

Spectral Sensitivity Characteristics of True Technology CMY filters

Looking at the spectral characteristics of the TT CMY filters, we can “pre-filter” the ICX098 CCD chip with the magenta filter including a suitable IR rejection filter. This will get rid of the band from 500nm to 600nm, and block both the G leak into Blue, and Red leak. Signal lost in R and B would be kept to a minimum.

We can reconstruct a synthetic G from the R and B (with a ratio that can be easily worked out). Since the G frame normally does not contain useful data for Mars, this will help to get better B and R frames using the ToUcam with very minimum modification and hopefully will encourage more submitted images with useful data.

Our final thoughts however, are perhaps while the ToUcam is a superb choice for producing high resolution colour imagery, perhaps the cooled CCD systems with proper filters still very much have the edge when one wishes to produce filtered imagery of Mars.

Best Regards,

Damian Peach
Tan Wei Leong.

ALPO-JAPAN 메일링 그룹에 현재 많은 좋은 사진들을 올리고 있는 영국의 Mr.Damian과 싱카포르의 Mr,Tan Wei Leong씨가 보내온 자료입니다.
ToUcam 사용하시는 분들은 참조하세요...

천체사진 카메라

천체사진 카메라의 모든정보(사용기,신제품정보,개조 등)

  1. SUPASLIM 48 FILTER WHEEL

  2. 로우패스 필터를 제거한 디카에서의 UHC filter 사용 TEst ~

  3. 캐논 1D Mark II 노이즈 Test

  4. *istDs 테스트 샷

  5. 1) 포토샵만을 이용한 DSLR이미지 처리[다크프레임 처리]

  6. 10D 오늘 사서 hot pixel검사해봤습니다.

  7. 10d 오리지날 색감....

  8. 10d 오리지날 색감....(2)

  9. 10D, 300D 이미지 처리 예

  10. 10D로 도시에서 일주 촬영하기

  11. 10d에 펜탁스렌즈.

  12. 10D와 D100의 비교기

  13. 10D화이트 밸런스

  14. 1장, 4장합성, FFT필터, DDP필터

  15. 300D + 셀레스트론 UHC필터(바더 OEM 제품)

  16. 300D CMOS 뜯어보기..

  17. 30D noise 특성

  18. 350D와 DSLRFocus

  19. 400D 30초 노출 dark사진.

  20. 40분 노출준 일주사진이라네요....(링크)

Board Pagination Prev 1 2 3 4 5 6 7 8 9 10 ... 13 Next
/ 13

NADA. Network of Amatuer Digital Astrography © Since 2003, All Rights Reserved

Design ver 2.0 / Google Chrome 에 최적화 되어 있습니다.

sketchbook5, 스케치북5

sketchbook5, 스케치북5

나눔글꼴 설치 안내


이 PC에는 나눔글꼴이 설치되어 있지 않습니다.

이 사이트를 나눔글꼴로 보기 위해서는
나눔글꼴을 설치해야 합니다.

설치 취소